KEITHLEY 2636A LABVIEW DRIVER DOWNLOAD

Thanks for the reply! I will measure transport properties while going low temp to high. Anyway, what value does the Advance Sweep return anyway? This come out in both the Keithley LCD and in labview Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.

Uploader: Kagashura
Date Added: 7 October 2007
File Size: 31.42 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 94320
Price: Free* [*Free Regsitration Required]

Anyway I now that I’m back, here’s what I managed so far:.

Search Instrument Driver Network

Using Labview to program Kethley a to produce voltage and measure current? So i am asking about the hardware required in interfacing.

Message 6 of Anyway, I just want to simply to program the Keithley A to run a certain voltage through the Hi and Lo cables, and read the output current. Message 3 of 4. Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type. From there decide which one makes sense based on the instrument’s front panel.

Applications Engineer National Instruments. Sir i can make interface with A with usb but i have other madel of lakeshore Model I know keithleg post is old but had the same problem and fixed it. The graph only show the values like the ouput from the string delivers, you can modify the shown digits. Message 4 of Break the problem into smaller steps and when you get stuck come back to this thread and let us know where you are stuck.

There are only two ways to tell somebody thanks: Message 1 of Anyway, what value does the Advance Sweep return anyway? Message 4 of In general a drive menu is created that is nothing more than a giant block diagram showing all the available functions.

My question is similar to this man’s question, albeit his program seems a bit too labviiew for me to understand.

Message 3 of I hope i understand the application correct the device put out a known voltage and you measure back the current so the resistance must be calulated.

Download and look at this manual: I used the Keithley example with the the driver to make the program. I am setting up a measurement where i need to source a voltage from the keithley and plot the current and resistance.

Message 7 of Well, I’ve been busy with my exams so I labivew reply immediately. I finally have the connection working properly. Message 4 of 4. Other than that I would check all of the actions that you are performing with the device to see if there are any conflicts where the same resource is needed for several tasks which could bring about an error such as this.

Keithley SourceMeter – Instrument Driver – National Instruments

Take a look at the Advanced Sweep Example and see if you can gather anything more from how the manufacturer uses triggers.

I am new to labview. Try the GPIB example: The problem I am facing is this.

Your Content I want to make interface between keithley A source meter and lakeshore temperature controller.